Doepfer A-191 Shepard Generator/16xMIDI-CV Interface (no l Manual de usuario Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 18
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
A-191
MCV 16
System A - 100
doepfer
6
4.2 Indicators and controls
1 LEDs
The LEDs
1
indicate the frequency of the internal
LFOs. They indicate the state of the sawtooth signal
at output S0 and/or the triangle wave at output T0 .
2 Freq. + • 3 Freq. –
Buttons 2 and 3 have a double function in the MIDI-
CV interface:
Setting LFO frequency
Pressing buttons 2 or 3 increases and/or de-
creases the frequency of the internal LFOs.
While buttons 2 or 3 are pressed, LEDs 5 and 6
blink to show the increase or decrease in the LFO
frequency. If you reach the upper or lower limit of
the frequency, the LED stops blinking.
H
It’s easier and definitely more precise to
alter the LFO frequency
by MIDI controller
#92.
Setting the MIDI input channel
If you simultaneously hold down buttons
2
and
3
,
"
learning mode
" is activated. This is signalled by
LEDs
5
,
6
and
8
all flashing at once.
You can now set the MIDI channel you want the
MCV16 to respond to. To do this, send a valid
MIDI
controller (see table 1) to the A-191. This automati-
cally ends learning mode, the LEDs go out, and the
MIDI channel of whatever controller was used beco-
mes the input channel for all the MIDI data sent after
this.
LFO frequency and MIDI- input channel are only tem-
porarily stored, unless you save them by pressing
button
9
(see below).
H The labels on LEDs
5
and
6
("Fast", "Slow",
"--") don’t have a function yet in MIDI-CV
mode, but are hoped to have in a future
update.
9 Reset / Store
To
save
the settings for
MIDI input channel
and
LFO
frequency press button 9.
LEDs
5
,
6
and
8
light for about a second to confirm
the save procedure has succeeded. At the same time,
all CV outputs are set to their default settings (see
table 1).
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comentarios a estos manuales

Sin comentarios