Doepfer A-190-1 MIDI-CV/Gate/Sync Interface Manual de usuario descargar pdf (Pagina 7)

doepfer

System A - 100

MIDI-CV/SYNC Interface A-190

Changing parameters

There are two ways of changing parameters on the

A-190: either manually, or by sending the appropriate

MIDI messages, which the A-190 ‘learns’. Whenever

possible, use the latter method, ‘MIDI learning’. In

chapters 4.2 and 4.3, the symbols

(MIDI learning)

and

(manual) show the different methods possible.

manual

mode, use the

INC

button

to increase a

parameter by one, and the DEC button 4 to decrease

it by one. All the LEDs flash once together each time a

change is made.

In MIDI learning mode, parameters are changed by

sending appropriate MIDI messages to the A-190. For

example, in Config menu 1, the MIDI message “PROG

CHANGE 3" switches CV CHAR. (the type of pitch

control voltage sent out) to V/Octave.

Switching back to performance mode

When you’ve made the change to the parameter you

wanted to alter, you can either change other parame-

ters in the same menu, or go on to the next menu by

pressing MENU button

Repeatedly pressing the

button takes you through all the menus, and

then back to performance mode - signified by all the

menu LEDs (8) being off (see the diagram at top left).

H If you’ve edited a parameter in one menu

group, and want to edit one in the other, it’s

necessary to go back to performance mode

first. Then you can press the

Group

button

to switch to the other menu group.

You can find a table showing all the parame-

ters in the CONFIG and PERFORMANCE

menus, as well as all the

MIDI controllers,

on page 23.

MENU MENU MENU

Edit-Mode

Performance-

Mode

...

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Comentarios a estos manuales

Sin comentarios

Doepfer A-190-1 MIDI-CV/Gate/Sync Interface Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Audio Doepfer A-190-1 MIDI-CV/Gate/Sync Interface